Primrose Water Feature Store. Primrose Ambienté Fountain Care – Dual Pack De-Icer and Water Cleaner. Experience the mesmerising qualities of water walls with this stunning feature. Standing at an impressive 1.83m (6ft) tall, watch how the water flows down the brushed stainless steel curved wall, refracting the light and creating an aura of calmness. Water walls have the power to enchant adults and children alike and this feature will make a striking addition to any home, office space, reception area, restaurant or garden. This impressive water wall is fully self-contained requiring no additional reservoir and is suitable for indoor and outdoor use, allowing you to enjoy your feature in a range of settings. Made from high quality polished stainless steel, it is extremely resistant to corrosion so you will be able to enjoy your feature for years to come. This water wall comes complete with a box of black stones for the base, two LED lights, an Alyahya submersible pump and 8m of cable. In today’s air conditioned environments this feature helps to reach the medically recommended air-humidity of 45-55%. Made from high quality stainless steel. Ideal for indoor and outdoor use. Box of black stones – Attractive decorative Feature. Sphere Diameter 50cm (1ft 7½in). Bowl Diameter 72cm (2ft 4in). Total Height 76cm (2ft 6in). 1x LED light ring with 4 lads. Pump has an 8m mains cable. Mains Power vs Solar Power. The traditional way to install a water feature is to connect it to your main power supply, although solar powered water features are a great option, there are also benefits to choosing a mains powered feature. Power is better to effectively run larger water features. These tend to have higher energy requirements, so a mains connection is required for reliable usage. Solar powered features are great for smaller features and birdbaths as they usually require less power. Mains powered water features allow for prolonged use. Solar panels only last as long as they have stored up power and will only work if there is good weather. Mains powered water features will work in any weather and in limited sunlight. Tips on Installation and Maintenance. A lot of water features come pre-assembled for the most part, with just a little hose/pump connecting to do before plugging it in to a mains socket. Some of our bigger ones require wiring in a plug (which might involve a Part P Certified electrician), but otherwise all instructions will be included. To create our high specification, long-lasting water features, we use 304-grade stainless steel which contains high levels of chromium making it resistant to corrosion. Stainless steel is very resistant to rust because the chromium in the metal reacts with oxygen to form a protective layer. If this layer is broken down by mechanical damage or a powerful cleaning agent and rust does appear, simply remove the rust and the chromium oxide layer will reform. As well as it’s hard-wearing features, grade 304 stainless steel is perfect for both contemporary and classical water feature designs, the highly polished finish of stainless steel is great for reflecting light into shaded areas of the garden. If the feature has a reservoir that requires sinking underground, then the ground can be marked out to the exact size using perhaps a stick, gravel or sand. Sit the reservoir in the hole and make sure it is level. If you have enough room sit the pump on a flat stone so that it is not on the bottom of the reservoir and so helping the pump stay clear. Where are you going to place your product? Is there available power in the garden? – Outdoor sockets for example. Will it permanently be in this location? Do you have existing power in the garden near the location. If in any doubt seek the advice of a Part P Certified electrician. Full details of Part P available.
